Tail Push Rod Ends: TREX 450X XL

The CNC tail push rod ends are designed to reduce slop and play of the Z-bend design of the stock tail push rod ends. The new design ultilizes two miniature threaded rods to enable connection to a new plastic ball linkage so a new ball system is available to replace the Z-bend design. For HS-50 servo users, a special plastic joint end with brass pin in included to connect the tail push rod ends to the servo arm. The new system is stronger, more precise and reduce most of the play and slop. It is designed to improve tail controls performance on the ALIGN T-REX X/XL helicopters.

Includes:
-2 x CNC tail push rod ends
-2 x miniature threaded rods preassembled
-1 x carbon rod (2x250mm)
-Special plastic joint end with brass pin are included to work with HS-50 servo


Requires:
-Loctite (#242 is recommended) all screws while assembling the tail pulley case into the heli.
-Require a T-REX aluminum linkage ball and plastic ball linkage to attach the aluminum push rod end to servo arms of HS-55 and HS56-HB servos, no additional hardware needed for HS-50 servos.